Led Feedback - Lutron Stanza SZ-IO Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
The SZ-IO receives its operating settings during
system startup. A device database containing
settings is transferred to the SZ-IO after it has been
addressed. This database includes settings for:
• CCO behavior (maintained vs. momentary)
• Momentary pulse time
• CCI programming action
• System presets

LED Feedback

The SZ-IO provides 7 LEDs for user feedback:
Status LEDs
LEDs 1 through 5 provide feedback for the CCOs
and CCIs. The display mode (CCO vs. CCI status)
depends on the position of DIP switch 7: The LED
lights when the CCO is active or when the CCI is
closed.
Switch up (on): CCI status displayed
Switch down (off): CCO status displayed
Addressing Mode LED
LED 6 will blink during addressing. A slow blink
(on for 3 seconds every 4 seconds) indicates an
unaddressed device. A fast blink (once per second)
indicates an addressed device. When not in
addressing mode, this LED is off.
RF Link Activity LED
LED 7 will blink when the SZ-IO receives or transmits
an RF packet.
4
SZ-IO Control Interface Installation and Operation
Diagnostic Mode and
DIP Switch Settings
Diagnostic mode allows the user to override the
contact closure outputs (CCOs) of the device.
DIP Switch Settings
Switch #
6 7
Mode
Normal
Normal
Diagnostic
Diagnostic
Switch up (On)
Switch down (Off)
Note: I n diagnostic mode, DIP switches 1–5 set the
override state of the outputs.
Diagnostic Mode Operation
1. E nter diagnostic mode. Move DIP switch 6 to the on
(up) position. LEDs 6 and 7 will flash together (once
per second) while the unit is in diagnostic mode.
2. S elect CCOs to override. Use DIP switches 1
through 5 to select which CCOs to close when the
addressing (ADDR) button is pressed. (The DIP
switch number corresponds to the CCO it controls.)
3. A ctivate the CCOs. Press the addressing button to
activate the CCOs you set using the DIP switches
in the previous step. The CCOs will remain active as
long as the button is pressed.
4. E xit diagnostic mode. Move DIP switch 6 to the
off (down) position. LEDs 6 and 7 will stop flashing
together.
Note: Diagnostic mode will exit automatically after 5
minutes of inactivity. Pressing the addressing button
will reset the inactivity time and the unit will remain in
diagnostic mode.
Internet: www.lutron.com/stanza
e-mail: product@lutron.com
Technical support: USA, Canada, Caribbean: 1.800.523.9466
Mexico: +1.888.235.2910
Central/South America: +1.610.282.6701
Warranty: 1-year limited warranty standard. 2-year parts and labor warranty, with
8-year pro-rated parts replacement on systems that include factory startup.
For complete warranty details, see the Start-Up/Warranty document provided with
your Stanza system specification submittal information.
These products may be covered under one or more of the following U.S. patents:
5,838,226; 5,848,054; 5,905,442; 6,687,487; 6,803,728; and corresponding foreign
patents. U.S. and foreign patents pending. Lutron and the sunburst logo are
registered trademarks and Stanza is a trademark of Lutron Electronics Co., Inc.
© 2009 Lutron Electronics Co., Inc.
Lutron Electronics Co., Inc.
Made and printed in U.S.A.
P/N 040-243 Rev. B 11.09.09
LED Display
Shows
Outputs
Inputs
Outputs
Inputs
R

Publicidad

Tabla de contenido
loading

Tabla de contenido