marklin 29411 Manual Del Usuario página 13

6. Operating the IR-Control
Selecting an address:
(The Locomotive address can
be found in the instuctions for
the locomotive).
Switch Adress
•
78
• •
72
• • •
60
• • • •
24
Changing an Address:
If you have 2 locomotives with the same address, you can
change the address for one locomotive as follows:
Unplug the transformer. Set the address switches (9*) to the
desired address. Press the button „Change Direction" (7*). Hold
this button pressed down while the lens (8*) on the IR-Control
shows to the receiver, and plug the transformer back into the
wall outlet.
Release the button as soon the light comes on. The programming
procedure is displayed when the light comes or blinks. As soon
as the light goes out, the programming is turned off. The locomo-
tive can now be run with the new address.

*
see illustration
6.1 Controlling the locomotive
Correct address selected? (See instructions for the locomotive)
When operating the IR-Control, always line it up with the lens in
the direction of the base station.
Press the desired button.
Braking
If no other commands are sent within 3 minutes of the last
command, the base station shuts off the voltage in the track for
safety reasons.
If the IR-Control is activated again after that, the base station
will turn itself on automatically.
If a short circuit occurs, the Base Station will shut off and will
turn itself on again after the short circuit has been corrected.
*
if locomotive is prepared
Turning on the light
Controlling Func-
tions 1 – 4 *
Accelerating
Changing
direction
13