Heath Zenith SL-6200 Manual De Instrucciones página 2

Ocultar thumbs Ver también para SL-6200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Install This End
Down
2.
Set the push button jumpers for each button to match
the respective chime receiver code. See "Code and
Tune Setting" section.
3.
Test range. Temporarily position push button where
you want it mounted. Press push button to verify chime
and push button work properly. If chime does not
sound, see Troubleshooting.
Remove
material in
screw hole
mounting with
screws
wall. Snap front of push button on.
When attaching push button using double sided tape, make
sure the surface of the door jamb or wall is clean.
1.
4.
Mount push button.
Use either screws or double sided
tape to mount push button.
To mount with screws, remove back
of case by pushing in tab on bottom
before
with a small screwdriver.
Remove material in screw hole. At-
tach back of case to door jamb or
Install alkaline type A23 12 volt
push button battery. Remove
back of case by pushing in tab
on bottom with a small screw-
driver. Make sure battery is
oriented properly (see page 5).
-2-
598-1144-00

Publicidad

Tabla de contenido
loading

Tabla de contenido