Introduction And Warranty; Acceptance - BOMBAS IDEAL SVAT Serie Manual De Instalación, Montaje Y Mantenimiento

Bombas Ideal, S.A.

1. INTRODUCTION AND WARRANTY

This service manual is intended for users of SVAT-SVHT pumps. It contains the instructions for
installation, service and maintenance.
Before proceeding to do any kind of work on the equipment, users should read this manual carefully and
pay attention to any suggestions and tips given in it, particularly the ones preceded by the following safety
symbols:
Failure to observe these instructions may expose people to serious danger for their
health.
Failure to observe these instructions may expose people to electrical risks.
TAKE NOTE Any instructions preceded by this message are of great importance for proper
installation, use and maintenance.
The instructions contained in this manual comply with EEC directive nº89/399 on machines, as well as
its subsequent modifications.
In order to improve the final result of its products, Bombas Ideal S.A. reserves the right to modify the
content of this manual and/or the product itself with no need to inform its customers beforehand.
Failure to comply with the suggestions and recommendations in this manual, as well as improper use
or non-authorised handling of the product, shall fully release Bombas Ideal S.A. from any liability as
regards possible damage caused, whether this be personal or material.
In the event of any doubt about the product, its use, maintenance or repair, please contact;
Bombas Ideal S.A.
Polig. Ind. Mediterráneo C/Cid nº 8
Tel. 34 961 402 143 Fax 34 961 402 131
46560 Massalfassar – Valencia – Spain
The manual is supplied along with the pump and should be kept close to the point of installation, duly
protected so that this can be consulted by users when required.

2. ACCEPTANCE

Check that the packing and shipping materials have not been damaged in transit, specially the inlet cable.
Make a report of any such damage and notify any irregularities at once.
If the pump is to be stored for any length of time, it must be kept in a dry place. The impeller of the pump
must be rotated by hand after a long period of being out of active service, to detect seizing due to
oxidation.