Dynsys System - Fantek T100D Manual De Usuario

DYNSYS SYSTEM

The Dynsys system is an optional solution to control the maximum load in our tower lifters.
The Dynsys limits the máximum load avoiding to lift a load bigger than the máximum load. The limitation
is do it for use as a machine system. For more information about the máximum load, check the load
table.
In case of lift a load bigger than the máximum of the tower, the Dynsys detects the incriase of load and
stops the elevation. In that case the load only can go down.
In case of limitation, the Dynsys advise with noise.
The Dynsys Works like a preventive maintenance. If the tower works with problems like damaged
internals, bad state of steel wire, the dynsys limits the maximum load decreasing it till the tower works
fine. If this happens, please contact with technical department or your local distributor.
The system allows to dismantle the lever. You can block the tower removing the lever. This is a form to
ensure that nobody alien to the show can move the tower up or down. You only need to remove the
Allen screws.
Figure 31
16
MANUAL DE USIARIO PARA TORRES DE CARGA SUPERIOR