Checking For Leaks - Cadac TRIO POWER PAK Manual Del Usuario

• Insert the gas cartridges into the unit by aligning the grooves, then push the
cartridge inwards and turn clockwise as shown (Fig. 4).
• Turn the control knob on the Power Pak anti-clockwise to increase the gas flow (Fig.
5).
• Then turn on the appliance you wish to operate, and light the appliance.
• Adjust the control knob, to reach the desired level gas flow to the appliance.
• Heat control to be done using the appliance control knob.
4. To disconnect the unit
• Close the control knob.
• Remove the cartridge/s by turning counterclockwise and remove.
• Disconnect the hose from the appliance and pack the unit away for storage.
• Cartridges should always be stored in a cool, dry, well-ventilated area.

5. Checking for leaks

• To check for leaks, apply soapy water to the connection areas and see if any
bubbles are visible. Any leakage will be seen as bubbles coming from the leakage
point. If you cannot remedy any leakage, return your product to your stockist.
Leaking gas cartridges can only be detected by the smell of gas.
6. Spares
• Always use genuine CADAC spares as they have been designed to give optimum
performance.
Item Spare No.
370-SP011
370-SP003
(30mbar)
370-SP013
(50mbar)
370-SP008
Item Spare No.
370-SP012
370-SP005
370-SP004
370-SP013
2 2
1.
Brass nut
2.
3.
Fig. 3
Fig. 4
Fig. 5
GB GB
Hand Wheel