Control Panel On Remote Control - Commercial Cool WPAC08R Serie Manual Del Usuario

SET UP & USE

CONTROL PANEL ON REMOTE CONTROL

˚F
AUTO
COOL
DRY
HEAT
TEMP
ON/OFF
MODE FAN SPEED
SWING ECONOMY TIMER ON
TIMER OFF
RESET LOCK
LED DISPLAY
Pictures are for illustration
purpose only. Your model
may or may not have all
the features.
Page 14 Page 14
• Temp down button: Decrease the indoor
temperature setting in 2°F (1°C) increments to 88°F
(30°C).
• Temp up button: Increase the indoor temperature
FAN
setting in 2°F (1°C) increments to 62°F (17°C).
HIGH
MED
• Mode: Each time the button is pressed, the
LOW
operation mode is selected in the sequence of the
following: AUTO › COOL › DRY › HEAT › FAN and
will return to AUTO and repeat the sequence after
FAN mode.
NOTE: · Heat mode is for Cooling & Heating models
only.
• ON/OFF: Starts and stops operation.
• Fan speed: Used to select the fan speed in four
steps: AUTO › LOW › MED › HIGH and will return to
AUTO and repeat the sequence after HIGH.
NOTE: · Some models do not have MED FAN
feature.
• Swing: Used to stop or start louver movement and
set the desired up/down airflow direction.
NOTE: · On models with auto swing function only.
• Economy (sleep): Select this function during
sleeping time. It can maintain the most comfortable
temperature and save energy. This function is
available on COOL, HEAT or AUTO mode only.
• Timer on: Activate the Auto-on time setting.
Each press will increase the time setting in 30
minutes increments, up to 10 hours, then at 1 hour
increments up to 24 hours. To cancel the Auto-on
setting, press the button until the time setting is
0.0.
• Timer off: Activate the Auto-off time setting.
Each press will increase the time setting in 30
minutes increments, up to 10 hours., then at 1 hour
increments up to 24 hours. To cancel the Auto-off
setting, press the button until the time setting is
0.0.
• Reset: Use to clear all previous settings and
controller will return to its initial settings.
• Lock: Lock all current settings. Press the LOCK
button again to cancel lock.
• LED display: Press this button to clear the display
on the current settings, press it again to illuminate
the display.