Electrical Connection; Description Of The Unit; Start-Up; Operation - Kärcher IVR-L 400/24-2 Tc Manual De Instrucciones

Electrical connection

The device may only be connected to an
electrical connection which has been set up
by a qualified electrician as per IEC 60364.
For the connection values see Technical
data and type plate. Use of an extension
cable is prohibited.
DANGER
Danger of electric shock
Danger of death
Avoid damaging the power cables by driv-
ing over them or otherwise crushing them,
or by jerking them.
Protect the cables from heat, oil and sharp
edges.
Check the mains connection of the device
for damage every time before operation.
Do not operate the device using a damaged
cable. Have any damaged cables replaced
by a qualified electrician.
Symbols on the device
Marking the maximum permissible fluid
level
See chapter Checking the filling level dis-
play.
ATTENTION
Risk of damage to the device
Leaking water due to the maximum fluid
level being exceeded.
Drain the device before the maximum fluid
level is reached.
Secure the device on the forklift
Note
When lifting the device with the forklift, se-
cure the chain of the device to the forklift.
14

Description of the unit

See graphics page for illustrations
Illustration A
Liquid container
1
Liquid container flap
2
Unlocking level flap
3
Suction hose connection
4
Suction head lock
5
Plugs
6
Suction head
7
Power switch
8
Mains cable
9
Filter
10
Screw plug
11
Deflector plate
12
Push handle
13
Maximum filling level mark
14
Drain hose
15
Steering rollers with parking brake
16
Tipping mechanism
17
Liquid container unlocking lever
18
Accessory holder
19
See graphics page for illustrations
1. Bring the device into the working posi-
tion.
2. If necessary, secure the device using the
parking brake.
3. Ensure that the suction head is fitted
correctly.
4. Insert the suction hose into the suction
hose connection.
Illustration B
5. Plug the desired accessory onto the suc-
tion hose.
See graphics page for illustrations
1. Plug the mains plug into the socket.
2. Switch on the device using the power
switch.
Illustration C
The switch has multiple level settings:
0The device is off.
1Motor 1 is switched on.
2Motors 1 and 2 are switched on.
3. Start vacuuming.
English

Start-up

Operation