Examples Of Use; Replacing The Batteries - tibelec EM4815 Guia Del Usuario

Examples of use

If there is any moisture on a wall and to identify the source of a possible water
leak, place the moisture tester in different locations on the wall to record the
most important measurement. This will make it easier for you to locate the
source of the leak.
Painting/furniture: check
the moisture level in a wall
before painting or varnishing
Tile : check the humidity
level before laying
Plants, agriculture, garden
Recommendations
• Gently place the measuring plungers on the surface; do not use force, blow
or pressure on the surface to be tested.
• Be careful when removing the protective cover (the plungers can hurt you).
• To use your device correctly and ensure that it will last for a long time,
observe the following precautions:
- Clean the measuring plungers regularly for optimal use.
- Make sure that the protective cap of the measuring plungers is correctly
repositioned when the device is not in use, to avoid any risk of accident.
- Do not leave within reach of children.

Replacing the batteries

When the symbol appears
Loosen the screw on the back of the device, open and replace the batteries in
the corresponding area with batteries of the same type, tighten again.
The consumer is obliged by law to recycle all used batteries and
accumulators. It is forbidden to throw them in the ordinary bin!
Refer to the environmental protection details.
8
:
:
:
, replace the batteries with new ones.
%
°C
Furnitures
Wallpaper : check the
humidity level before
laying
Printer : check the
humidity in the paper
before printing