Nordelettronica NE274-FV Instrucciones Para El Uso página 4

CONTROL PANEL NE274
GB
CONTROLS:
Push button with warning light for turning
INTERNAL LIGHTS on or off
Push button with warning light for turning
INTERNAL LIGHTS on or off
SCREENS:
The warning light goes on when the 230V mains is connected
The warning light goes on when
The warning light goes on when the recycling tank R1 is ful.
Press the push button for viewing the level percentage % (0, 33, 66, 100) of the reservoir S1.
If S1 is empty, the display flashes.
If the tank is wrongly connected, the display will show "
The screen remains active for approx. 30 seconds.
Press the push button once to see the voltage on the service battery (B2), Press the push button
again to see displays the % the remaining battery.
Only in the view as %, if there is
to indicate the battery charge.
The screen remains active for approx. 30 seconds.
Press the push button once to see the voltage on the starter battery (B1), Press the push button
again to see displays the % the remaining battery.
Only in the view as %, if there is
to indicate the battery charge.
The screen remains active for approx. 30 seconds.
ALARMS:
Batteries: Car battery (B1) less than 11,8V or Service battery (B2) less than 10V.
In this case there is a bleep (if enabled) and the flashing battery button that have generated the alarm
(for the first 30 seconds you see the value)
Hold for more than 3 seconds (
alarm
Tanks: Tank S1 empty
In this case there is a bleep (if enabled) and the flashing symbol tank that raised the alarm (for the first 30 seconds
you see the value)
Hold for more than 3 seconds (
tank
Beep: Hold for more than 3 seconds (
confirmation beep button pressed, and alarm buzzers
: This symbol appears when there is an error communicating with NE185 shunt.
CONSUMPTION:
To turn on the control panel you must touch for 1 sec. the right or left side panel where there are the keys.
On stand by (no active controls) the control panel with shunt NE185 consumes a total of approx 40mA. When the key (
pressed the control panel turns itself off and total consumption is reduced to just 3mA.
If the service battery voltage drops below 10V, after 1 minute the control panel turns itself off, together with all live parts.
CONNECTIONS:
The back of the panel has a connector for serial connection (JP8)
the vehicle engine is running and the parallel batteries is active.
the displayed value of the select battery is replaced with the moving segments
the displayed value of the select battery is replaced with the moving segments
) button can be disabled (show "
) button can be disabled (show "
) button can be disabled (show "
4
Push button with warning light for turning
PUMP on or off
".
") or enabled (show "
") or enabled (show "
") or enabled (show "
GB
") the low battery
") the alarm of
") the the
) is