EnGenius ERB9260 Guía Rápida página 4

One-Touch Setup (Quick Setup)
1. Click [WPS] button on ERB9260.
2. Click [WPS] button on the Access Point.
Note:
When performing the above set up, ERB9260 must be near to the HomeAP.
It takes up to 60 seconds to clone the AP. Please wait until WPS led stops blinking and stay ON.
If the connection is successful. There will be TWO HomeAP in the environment.
3. Please use your wireless utility to rescan the APs and reconnect to the HomeAP
closest to you. Your wireless card should pick up the AP with strongest signal.
Note: To re-configure the ERB9260 you will need to reset the device to factory-default by pressing the WPS
button for 15 seconds.
Quick Guide
Thank you for choosing EnGenius