Hyper Tough Q01DA0442-08 Manual De Instrucciones

FOR FIRST TIME USE: SOLAR LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 8 -12 HOURS WITH THE SWITCH IN
THE "ON" POSITION TO FULLY CHARGE THE RECHARGEABLE BATTERY.
IF INSTALLING MORE THAN 1 LIGHT, YOU MUST LINK YOUR LIGHTS FIRST BEFORE INSTALLATION BEGINS. YOU MAY
LINK UP TO 20 LIGHTS. AFTER THE LIGHTS ARE LINKED YOU MAY BEGIN THE INSTALLATION PROCESS.
The intelligent solar LED motion activated light measures the corresponding available battery power through the current voltage point of
the battery, adjusts the energy and lumen output, and maximizes the lighting time.
Tools Required
Pencil
Phillips-head
Screwdriver
1
Marking the location
Mark the location where you want to mount the light xture (Part C) .
Measure the width of two holes on the back of the solar fence
light to align holes for the 2 screws (Part A) on the surface. The
distance between the two holes is 5.73in. (145.5mm).
Drill two holes.
2
Mounting the light
wall anchors Part
Insert the (
Part
Insert the screws ( A) and leave at least 1/4in. (6.3mm) of the
Part
screws ( A) outside of the surface for holding the solar fence light.
Mount the light on the screws (
on the back of the light over the screw heads.
TROUBLE SHOOTING
If the light does not turn on, remove the
battery cover and check if the battery
pack is connected to the battery
connector. If the connection is ok,
replace the battery with a new one.
WARNING:
Do not dispose of lithium batteries in municipal waste stream or by re as batteries may explode. Do not open, short circuit, or destroy
batteries. Dispose of batteries in accordance with Local, State, and Federal regulations. Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel cadmium, nickel metal hydride or lithium ion) batteries .
© Wal-Mart Stores, Inc.
Hyper Tough is a registered trademark of
Wal-Mart Stores, Inc. All Rights Reserved.
Distributed by/Distribuido por
Wal-Mart Stores, Inc.,
Bentonville, AR
MADE IN COUNTRY/HECHO EN COUNTRY
TM
Electric drill
drill bit size:
ø7.5mm (3/10 in.)
B) so they are ush with the surface.
Part
A) by placing the keyholes
Slide the power switch to the "OFF" position. Use a
Phillips head screwdriver to remove the 5 screws
holding the battery cover in place. Gently pull battery
pack away from the light xture and disconnect the
battery connector. Replace old battery pack with a
new 3.7V, 2400 mAh lithium (18650) rechargeable
battery pack. Connect the battery connector and insert
battery pack into the light xture. Replace the battery
cover by aligning it properly and replacing the 5 screws
removed earlier. Slide the power switch to the "ON"
position.
For optimal performance, allow light xture to charge in direct
sunlight for 8-12 hours to fully charge the battery.
For assistance with assembly or instruction, parts and customer service, call: U.S.A. & Canada only: 1-844-551-0680
8am – 5pm Monday – Friday, Central Standard Time Or email: Customerservice@qx-usa.com
INSTRUCTIONS
INSTALLATION
Hardware Included
(A)
Screw X 2
Parts
A
B
REPLACING THE BATTERY
LINKABLE SOLAR LED PATHWAY LIGHT
ITEM: Q01DA0442-08
(B)
Wall Anchor X 2
(C)
Light Fixture X 1
5.73in.
x x
C
Screws
Power switch
Battery Cover
Battery pack
A
Battery connector
10/22/2019
1/2E