Stand Installation - Newskill ICARUS 27 Manual Del Usuario

3. Stand Installation

EN
Keep the foam underneath the monitor before attaching the stand.
Open the package, take out the product with foam still
1
attached, and gently place it on a desktop or table.
Remove the top cover of the Foam, then take the body
3
out of the film-coated bag, and put it into the cavity of
the bottom cover of the foam.
8
ICARUS SERIES
Foam
Hold the bracket with both hands to place a flat desktop and use the
5
machine by plugging in the cable.
When disassembling, follow the opposite steps, Make sure the monitor is
laid on a flat surface before removing the stand.
Take the base and stand of the monitor. Insert the stand
2
into the base. Use 2 PM3*14mm screws to tighten
(An 1 extra spare screw is provided), and then use the
provided rubber feet to seal the bottom hole where the
bottom screw is located.
Stand Stem
Screws x 2
Base
Align the assembled stand with the opening on the
4
back of the monitor.
Carefully insert the bracket into the opening. Fix the
bracket to the monitor with four CM4*26mm screws.
(An 1 extra spare screw is provided).
Screws x 4