How To Use (Bending) - Metabo HPT VB 16Y Manual De Instrucciones

WARNING:
To prevent accidents, always be sure to turn the
switch OFF and unplug the power cord from the
receptacle.
If you remove the hexagon socket bolt using the
provided Allen key, you can remove the cutter.
(Pushing the cutter guard up in the direction of
the arrow shown in Fig. 10, facilitates removal of
the upper cutter.)
4. Mounting
(1) Get rid of dust around the cutter installing section and clean it up.
(2) Align the hole of a new cutter and the position of a pin, and insert into the installing
section.
(3) Also replace the hexagon socket bolt (packed along with the cutter) with a new one
simultaneously, completely tighten it using the attached Allen key, and then fix the
cutter.
CAUTION:
G
Install the cutter and accessories securely according to the instruction manual. If you
fail to install them properly, they may come off and cause an injury.
G
Be sure to unplug the power cord from the receptacle when the cutter is checked,
cleaned, and replaced. Failure to do so can result in a serious injury.

HOW TO USE (BENDING)

1. Setting bending angles by setting dial
The bar can be bent according to the angles indicated on the setting dial, as shown in
Fig. 12.
Dial indication
Condition of rebar
In bending the rebar of #3(3/8"), #4(1/2"), and #5(5/
8") diameters, a difference takes place in the
bending angle even in the same dial position
depending upon the difference of rebar's
thickness. Slightly change a position of the setting
dial depending upon the rebar's diameter even
with the same bending angle as shown in Fig. 13.
45°
45° 90°
90°
135°
Fig. 12
English
Fig. 11
135° 180°
180°
Adjusting position
Fig. 13
17