Cequent Towing Products Pro SOLO 1040100 Manual Del Usuario

Please read all instructions carefully before assembly, installation and/or use of this product.
WARNING: The Maximum capacity is 400 pounds. DO NOT EXCEED lower of vehicle mfg's or hitch mfg's maximum tongue
weight rating. Use with class 3 or higher 2" receiver hitch.
WARNING: Keep tip of vehicle exhaust pipe clear of obstructions. Use an additional exhaust tip to redirect exhaust if carrier or
cargo is in-line with exhaust. A blocked exhaust tip can cause fire or carbon monoxide to back up into vehicle.
WARNING: DO NOT transport people, animals, or flammable liquids on the cargo carrier.
WARNING: DO NOT carry any loads wider than your vehicle.
WARNING: DO NOT use as a seat or step.
WARNING: Securely fasten load to cargo carrier.
WARNING: Use light kit #6504 if the load or cargo carrier blocks the taillights or turn signals.
WARNING: Relocate license plate if blocked by load or cargo carrier.
WARNING: Do not cut, drill, weld, or modify this product.
During Transport: Drive slowly on rough roads - Severe bumps can damage your tow vehicle, hitch, and cargo carrier. Stop and
make a thorough inspection if your cargo carrier strikes the road and correct any problems before resuming travel.
Check security of load, fasteners, pin, and clip at fuel and rest stops.
5/8" PIN
TIE DOWN HOLES
(10) PLACES
ASSEMBLY INSTRUCTIONS:
1. Insert shank into your vehicle's hitch receiver and secure with 5/8" pin and clip supplied.
2. Set the cargo basket on top of the shank lining up the two square holes in the center of the basket with the holes in the
shank. Loosely install the 3/8" x 3.00" long carriage bolts through the basket and shank.
3. Install the reinforcement bars onto the 3/8" carriage bolts as shown and loosely install the 3/8" lock nuts.
4. Install the 3/8" x 1.00" long carriage bolts through basket and reinforcement bars and loosely install the 3/8 flat washers and
3/8" lock nuts.
LOADING
Load the Cargo Basket so that most of the weight is in the center of the platform.
Cequent Performance Products
47774 Anchor Court West
Plymouth, MI 48170
Technical Service: (888) 521-0510
CLIP
FIGURE 1
Tighten all 3/8-16 GR5 fasteners with torque wrench to 30 Lb.-Ft. (40 N*M)
CORRECT
Item:
SOLO™ Cargo Basket
Description:
SHANK
License plate relocation holes
(FOR DAYLIGHT USE ONLY)
INCORRECT
1040100
TOOLS REQUIRED:
9/16 Wrench
3/8-16 x 1.00 GR5
CARRIAGE BOLT
FLAT WASHER 3/8
3/8 LOCK NUT
(4) PLACES
3/8-16 x 3.00 GR5
CARRIAGE BOLT
3/8 LOCK NUT
(2) PLACES
REINFORCEMENT BAR
(2) PLACES
Printed in China
1040100N REV D 9-15-09