Publicidad
Idiomas disponibles
Idiomas disponibles
Install the Fixture
1A
FIXTURE SCREW
1
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
Secure the mounting plate to the junction box.
2
Screw the screw collar tightly onto the threaded nipple.
3
Insert the glass panels into the shade and secure them using the panel screws and washers.
4
Install the shade to the fixture and secure them together using the fixture screws.
5
Determine the wanted height of the fixture and remove a portion of the chain by opening a link and removing it from the
6
bottom.
Install the canopy and the collar nut onto the chain (in that order), then install the open link onto the fixture loop and secure
7
it in place by closing the link.
Open a link on the other end of the chain with pliers and install the chain onto the screw collar to secure the fixture, re-close
8
the link.
Weave the cord through the fixture loop, chain, screw collar, canopy, threaded nipple, and out of the junction box. Trim the
9
cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
10
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
11
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
12
Neatly place all the wires into the junction box, place the canopy onto the ceiling, and secure it in place by screwing the
13
collar nut tightly onto the screw collar.
JUNCTION BOX
MOUNTING PLATE
CANOPY
SCREW COLLAR
FIXTURE
4
12
11
THREADED NIPPLE
1
COLLAR NUT
CHAIN
FIXTURE LOOP
4
5
5
2
PANEL SCREW & WASHER
GLASS PANEL
SHADE
Publicidad
