Accessories And Spare Parts; Scope Of Delivery; Safety Devices; Symbols On The Device - Kärcher MT CS 250/36 Manual De Instrucciones

Accessories and spare parts

Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.

Scope of delivery

The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.

Safety devices

CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
Bucking spikes
The integrated bucking spikes can be used as a fulcrum
to give the saw stability during a cut.
When sawing, press the device forward until the metal
pins penetrate the edge of the wood. Subsequently
moving the shaft up or down in the direction of the cut
reduces the physical strain when working with the saw.

Symbols on the device

General warning symbol
Read the operating instructions and all
safety instructions before operating the
device for the first time.
Always wear suitable eye protection and
hearing protection when working with the
device.
Wear non-slip, sturdy gloves when work-
ing with the device.
Wear non-slip safety shoes when work-
ing with the device.
Electrical hazard. Keep a minimum dis-
tance of 10 m away from overhead lines
10m
when working with the device.
Danger due to flung objects. Keep spec-
tators, especially children and pets, at
least 15 m away from the work area.
Lubrication of the guide rail and the chain
14
Running direction of the chain

Protective clothing

DANGER
Risk of fatal injury from cut injuries. Wear suitable pro-
tective clothing when working with the device. Observe
the local regulations for accident prevention.
When working with the device, wear a suitable safety
helmet that complies with EN 397 and is CE marked.
When working with the device, wear hearing protection
that complies with EN 352-1 and is CE marked.
For protection against flying splinters, wear suitable
safety goggles that comply with EN 166 or are CE
marked. Or wear a helmet visor that complies with EN
1731 and is CE marked.
Protective helmets with hearing protection and a safety
visor are available in specialist shops.
Wear suitable protective gloves with cut protection
equipment that comply with EN 381-7 and are CE
marked when working with the device.
Wear non-slip safety shoes that meet EN 20345 and are
CE marked when working with the device.

Description of the device

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
See graphics page for illustrations
Illustration A
Bar scabbard
1
Screw for adjusting the chain tension
2
Chain
3
Guide rail
4
Chain oil tank cap
5
Bucking spikes
6
Guide rail nut
7
Bar cover
8
Shaft
9
Type plate
10
Assembling the Multi-Tool
1. Connect the shaft with the coupling of the Multi-Tool
(see operating manual Multi-Tool MT 36 Bp).
Illustration B
Filling the chain oil tank
1. If necessary, clean the area around the filling hole of
sawdust and dirt.
2. Remove the chain oil tank cap.
Illustration C
3. Slowly fill the chain oil into the tank.
Illustration D
English
Head protection
Protective gloves
Safety shoes

Initial startup