Black and Decker TV293 Manual De Instrucciones

E
N G L I S H
INSTRUCTION MANUAL
TV292 9.6 VOLT / TV293
12.0 VOLT POWER PACKS
& CHARGERS
The batteries in your new power pack are
not fully charged. First read the safety
instructions below. Then follow charging
notes and procedures.
WARNING: FOR SAFE OPERATION READ INSTRUCTION
MANUAL.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using electric tools basic safety precautions
should always be followed to reduce the risk of fire, electric shock,
and personal injury including the following:
READ ALL INSTRUCTIONS
1. Do not incinerate the power pack even if it is severely
damaged or is completely worn out. The power pack can
explode in a fire.
2. A small leakage of liquid from the power pack cells may occur
under extreme usage or temperature conditions. This does not
indicate a failure. However, if the outer seal is broken and this
leakage gets on your skin –
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If battery liquid gets into your eyes, flush them with clean
water for a minimum of 10 minutes and seek immediate
medical attention. (Medical note: The liquid is a 25% -35%
solution of potassium hydroxide.)
3. Never attempt to open the power pack for any reason.
If the plastic housing of the power pack breaks or cracks,
immediately discontinue use and do not recharge.
4. Do not carry extra "charged power packs" in aprons, pockets,
or tool boxes along with other metal objects. Power pack could
be short circuited causing damage to the power pack and
possibly causing severe burn or fire.
5. Charge the power packs listed above only in a Master
Mechanic charger.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
SPECIFICATIONS
POWER PACKS
TV292 9.6V DC USE WITH 382893-00
9.6V CHARGER ONLY.
TV293 12.0V DC USE WITH 382893-01
12.0 V CHARGER ONLY.
Charger (382893-00)
Input 120V AC
60Hz
5.6W
Output 11.6 DC-165mA
Charger (382893-01)
Input 120V AC
60Hz
7.2W
Output 14.5V DC-200mA
Charging Procedure
THE BATTERIES IN YOUR POWER PACK ARE NOT FULLY
CHARGED AT THE FACTORY. BEFORE ATTEMPTING TO CHARGE
THEM, THOROUGHLY READ ALL OF THE SAFETY INSTRUCTIONS.
To charge the power pack from your drill, follow the steps below.
1.
Remove the power pack from the tool, as shown in Figure 1.
2. Plug the appropriate charger into any standard 120 V 60 Hz
electrical outlet.
3. Insert the power pack into the charger, as shown in Figure 2
and let it charge for 3 hours.
4. Remove pack from the charger and replace in tool, as shown in
Figure 3.
5. If the power pack is run down completely, it may take up to 8
hours to become fully charged.
NOTE: A power pack will slowly lose its charge when kept out
of the charger. If the power pack has not been kept on
maintenance charge, it may need to be recharged before use.
FIG. 2
FIG. 1
FIG. 3