Pulp Regulator Settings - Weston 36-3801-W Manual De Instrucciones

All manuals and user guides at all-guides.com
4. Position the Auger Retainer on the
Juicer Body, until the Auger Shaft
protrudes from the middle of the Auger
Retainer. FIGURE 3
5. Align the "U" portions of the Auger
Retainer with the screw holes on
the Juicer Body. Secure the Auger
Retainer to the Juicer Body using the
two Thumbscrews with Cap Washers.
FIGURE 3A
NOTE: Before securing, make sure
the Rubber Seal is properly positioned
between the Juicer Body and Auger
Retainer.
6. Line up the flat edge of the Handle
with the flat edge of the Auger Shaft.
Place the Handle onto the end of the
Auger Shaft, securing with the Handle
Thumbscrew with Cap Washer.
FIGURE 4
7. Screw the Pulp Regulator
clockwise onto the top of the end on
the Juicer Body.

PULP REGULATOR SETTINGS

• By adjusting the Pulp Regulator up
and down, you can determine how
much juice is extracted from the pulp.
This setting is a personal preference
and results can be determined
during the early stages of using your
Wheatgrass Juicer for the first time.
• MORE EXTRACTION: Turn the
Pulp Regulator clockwise to move
the Pulp Regulator down and apply
more pressure to the wheatgrass
as it is being squeezed, resulting in
more juice.
• LESS EXTRACTION: Turn the
Pulp Regulator counter-clockwise
to move the Pulp Regulator up
and apply less pressure to the
wheatgrass as it is being squeezed,
resulting in less juice.
6
Auger
Thumbscrews
Shaft
with Cap
Washers
Auger
Retainer
FIGURE 3A
"U" portions
Rubber
Seal
Auger
Retainer
Handle
Thumbscrews
with Cap
Washer
FIGURE 3
FIGURE 4
Pulp
Regulator