Smith Performance Sprayers R301 Guia De Inicio Rapido

1. Assemble Hose To Tank
IMPORTANT: Do not attempt to heat or alter
hose, hose nut, or barb prior to assembly.
. Align hose barb tabs, push hose barb into tank
1
until it stops (See Figure A).
2. Slide hose nut into place and turn clockwise to
tighten. (See Figure B).
NOTE: Do not use tools to tighten hose nut.
2. Assemble 24" Brass Wand
Place 176332 check valve inside of 182566 brass
wand. Then place brass teejet nozzle and cap on
top and screw into place (See Figure C)
Note: Check valve must be always be used.
3. Assemble XL Valve to Hose
Screw on XL Valve to end of hose from sprayer. Using
a 9/16" wrench for sprayer hose and a 3/4" wrench for
the XL Valve tighten securely. (See Figure D)
4. Assemble Wand to XL Valve
Screw on Wand Assembly to XL Valve using a 13/16"
wrench. (See Figure E)
QUICK START GUIDE
SETTING UP YOUR CONCRETE R301 SPRAYER
190451
Figure A
Check Valve
Configuration for nozzle tip sprayers
Disassemble adjustable nozzle to use cap nut with nozzle tip.
182563 XL VALVE
Wand Assembly
Figure B
182566 Brass Wand
Figure C
Backpack Hose
Figure D
182563 XL VALVE
Figure E