Pima FORCE Serie Guia De Inicio Rapido

Quick Start Guide for the FORCE Series Alarm Systems
This guide should be served as a start guide for the FORCE Series intruder alarm systems, after it was installed
and connected to power by a certified technician.
Verify that the time and date are displayed on the keypad's screen. If not, press the
and hold it for two seconds.
User codes
1. Enter the Master code to enter the User menu. If you have any other user code, press the menu button
on the keypad and enter your code.
2. Press the down arrow (
User Codes
3. Press on
User 1
4. In screen, press
5. Press to save the code.
6. To set the user name and other settings, refer to the User guide.
7. To set more users, press the pound key (#) to scroll to the next user.
8. Press the several times to exit the menu.
Arming and Disarming
1. Before arming your alarm system, make sure "Ready to Arm" is displayed, and the green LED is
illuminating - close all the zones that are not in the exit path, and verify there are no faults, or you will
have to override them (refer to the User guide).
Away
2. To arm , enter your user code and leave the premises before the exit delay expires.
Home
3. To arm in a
your user code).
4. To disarm, enter your user code.
For the complete user options, download the FORCE's User guide from PIMA website at: https://www.pima-
alarms.com/download/.
Safety Instructions. Read Carefully!

Hazards of fire and electric shock exist in this alarm system. To reduce the risk of fire or electric shock, do not expose
this alarm system to rain or moisture. Pay attention: Telephone cords could be a good conductor for lightings energy.

Warning: this equipment has no mains On/Off switch. The plug of the direct plug-in power supply is intended to serve
as the disconnecting device.

Dangerous high voltages are present inside the control panel's enclosure. Refer servicing to qualified personnel only.

This alarm system should be used with 230VAC/110VAC, 50/60Hz, protected by anti-electric shock breaker. Use only
the power supply provided with this equipment. Use of unauthorized power supplies may cause damage.

Do not spill liquid of any kind onto the unit. If liquid is accidentally spilled onto the unit, immediately consult a
qualified service.

Disposal of used batteries must be made in accordance with local waste recovery and recycling regulations.
Copyright  2020 PIMA Electronic Systems Ltd. All rights reserved. E&OE
Manufactured by:
PIMA Electronic Systems Ltd.
www.pima-alarms.com
5 Hatzoref Street, Holon 5885633, ISRAEL
Tel: +972.3.6506414 Fax: +972.3.5500442
Email: support@pima-alarms.com

on the right-hand side) to scroll to
.
Code
on and enter a four to six digit code. Keep the code in a safe place.
mode, press and hold the home key
Users and Codes
until a sound is heard (you may have to enter
-1-
several times, or press
, and press .