EASYHOME STB 8117B Manual De Instrucciones

Easy Home Bedroom Projection Light User Instructions_LADYBUG_2016_LIVE-ENGLISH_A4_V2.pdf
LADYBUG
BEDROOM PROJECTION LIGHT
HOW TO USE
1. Pull the tab out from the bottom of the unit to activate the batteries. If the tab is no longer there, the batteries may need to be replaced.
2. Place Projection Light on at surface.
3. Touch the back of the Projection Light at the 'Touch Sensor' to turn it on and o .
1st Touch: Activates ORANGE projection
2nd Touch: Activates BLUE projection
3rd Touch: Activates GREEN projection
4th Touch: Activates RED projection
5th Touch: Activates color rotation projection (Changes color approximately every 15 seconds)
6th Touch: Turns o
NOTE: The Projection Light has an automatic shut o after approximately 45-50 minutes. This could vary based on battery life.
NOTE: The light projects between 3 to 9 feet based on battery life.
HOW TO CHANGE THE BATTERIES
1. Using a small Phillips screwdriver, remove the screw from the bottom of the unit.
2. Open the battery compartment lid.
3. Remove old AA batteries from compartment.
4. Insert three new AA batteries, ensuring that + and – match for polarity.
Do not mix old and new batteries.
5. Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, nimh, etc.) batteries.
6. Close the battery compartment lid.
7. Tighten screw into compartment lid.
SAFETY INSTRUCTIONS / SAFETY WARNING
1. Read and understand all instructions.
2. Although your Bedroom Projection Light is easy to operate, for your safety, the warnings below must be followed:
A. Do not place the Projection Light near a heat source.
B. Place the Projection Light on a at surface away from water.
3. Although this Projection Light is meant for a child's bedroom, it is not a toy. Close supervision is recommended when children
are using this item. Keep out of reach of small children.
4. Failure to follow instructions may result in damage to the device or injury to the user.
5. The device is intended to be operated by an adult.
SERVICE CENTER
If you have any questions in regards to the
operation of this Bedroom Projection Light
please contact AFTER SALES SUPPORT.
ENVIRONMENTAL PROTECTION
If the Bedroom Projection Light should no longer work at all, please make sure that it is disposed of in an environmentally friendly way.
This device complies with Part 15 of the FCC Rules. Operations is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation".
Warning: Changes or modi cations to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit di erent from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Made in China / Hecho en China
DISTRIBUTED BY / DISTRIBUIDO POR:
ALDI INC. BATAVIA, IL 60510
www.aldi.us
USER INSTRUCTIONS
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY.
1 6/30/16 2:43 AM
CLEANING AND
MAINTENANCE
1. Use a dry soft cloth ONLY to
clean the exterior of the light.
2. NEVER immerse Projection
Light in water or any
other liquid.
AFTER SALES SUPPORT •
SERVICIO POSVENTA
50841
1-888-367-7373
help@myproduct.care
MODEL: STB 8117B 10/2016
SAVE THESE INSTRUCTIONS!
YEAR WARRANTY
AÑOS DE GARANTÍA