Assembly - EASYHOME HC-T51M Manual Del Usuario

Oscillating Ceramic Tower Heater

ASSEMBLY

1. Remove tie from power cord and unravel
the power cord.
2. Connect the front base to the rear base by
placing attached pegs into the appropriate
holes.
3. Slide the power supply cord through the
assembled base from the top. (Fig. 1)
4. Position the connected base pieces where
the front base piece is facing in the direction
of the front grill.
5. Move base so the screw holes align
properly. Using the 4 base screws provided
(taped to the Tower Heater), secure the
base to the bottom of the Tower Heater.
(Fig. 2)
6. Once the base is secured, unscrew one side
of the cord holder on the bottom of the
base. Place the power supply cord in the slot
and replace the screw. The power supply
cord should now fit in the groove on the
back of the rear base. (Fig. 3)
CAUTION
Do not use your Tower Heater if it has not been
fully assembled. Make sure that the screws that
hold the base parts and the main unit together
are tightened securely.
4
888-367-7373
___ _____
Fig.1
Fig.2
Fig.3
AFTER SALES SUPPORT
customer-service@wk-usa.com
_ASSEMBLY