Megger MIT400/2 Guia De Inicio Rapido página 4

■
■
■
■
■
■
■
■
■
■
■
■
■
■
■
m
MIT400 and MIT2500 series safety warnings
National Health and Safety Legislation requires users of this
assessments of all electrical work so as to identify potential sources of electrical danger and risk of electrical inJury such
as inadvertent short circuits.
Where the assessments show that the risk is significant then the use of
The voltage indicator and automatic discharge features must be regarded as additional
substitute for normal safe working practice which MU5T be followed.
The circuit under test must be switched
are made when carrying out insulation and continuity tests.
Test voltages greater than 1 000V de
Circuit connections greater than 15
under test must not be touched during testing.
The Voltmeter function will operate
After an insulation test, the instrument must be
Do not handle test leads above the 1000
The instrument should not be used if any part of
All test leads, probes and crocodile clips
test
the integrity of the leads before making measurements. Only
this product.
Ensure that hands remain behind finger guards of
National Safety Authorities may recommend
systems
Fused Leads must be tested independently before use to ensure fuse integrity.
Replacement fuses must be of the correct type and rating. Failure to fit the correctly
hazard and may cause damage to the instrument in the event of an overload.
All covers must be in place whilst conducting tests.
If this equipment is used in a manner not specified
may be impaired
■ The instrument must be used only by
Safety symbols marked on the instrument
/!\
Refer to user instructions
Lh
Risk
of electric shock
600V ac rms maximum between
CATN600V
terminals, and between terminal
and earth
Enclosure is dust proof and
IP54
protected against waters-plashes
Fuse FF 500mA 1000V 30kA
Installation category definitions:
CAT IV - Measurement Galegory IV: Equipment connected
between the origin of the low-voltage mains supply and the
distribution panel.
CAT Ill - Measurement Galegory Ill: Equipment connected
between the distribution panel and the electriG31 outlets.
CAT II - Measurement category II: Equipment
between the electriG3I outlets and the user's equlpmenl
4 MIT400/2 and MrT2500
equipment and their employers to carry out valid
fused
off. de-energized. securely isolated and proved dead before test connections
must not be used on capacitive circuits. Capacitive charges can be lethal.
nF. exposed-conductive-parts and other metalwork of
only if the instrument is switched on and working correctly.
left connected until the circuit has been discharged
V range. (For use in dry conditions only).
it is damaged.
must be in good order, clean and with
"Megger"
probes/clips.
the use of fused test leads when measuring voltage on high-energy
by the manufacturer, the protection provided by the equipment
suitably trained and competent persons.
CE:
UK
CA
&
-
Measurement equipment may be safely connected to curuits at the
marlced ra�ng or lower.
This instrument is manufactured
the right to change the specification or design without prior notice.
Megger is a registered trademark.
connected
risk
test leads may be appropriate.
safety features and not a
an installation or equipment
to a safe voltage.
no broken or cracked insulation. Verify
approved test leads must be used with
rated fuse may result in a safety
Equipment protected throughout
by Double Insulation
Equipment complies with current
EU directives.
Equipment complies with current
UKCA directives
N13117 Equipment complies with
n
current "C tick requirements
Do not dispose of in the normal
waste
rtream.
in the EU. The company reserves
www.megger.com
4/8