Thetford N3000 Serie Manual Del Usuario página 108

EN
3 Switch on refrigerator
After 10 seconds the settings will dim. The green
light indicates the refrigerator is still in function.
To check the settings push the on/off switch.
The last selected settings will light up.
To secure optimal performance, level your
vehicle before operating the refrigerator.
For optimal performance, switch on the
refrigerator 8 hours before placing food.
We advise to clean the inside of the
refrigerator properly, before using your
refrigerator.
4 Selecting source
Sources
Auto
230V
12V
Gas
If you set the refrigerator on the automatic source
selection, the control panel will show two source
symbols; the A and the best source available.
If the 'auto' function on the refrigerator is
selected, but no source is available, a light in the
on/off switch blinks red.
Always use the gas connection or mains voltage
to start up and cool. Operating on 12V is only
effective while the engine of the vehicle is running.
To switch on the
refrigerator, push the on/off
switch and hold it for
1 second, as illustrated.
A light in the on/off switch
will turn green.
After switching on the
refrigerator, push the
source button several
times, as illustrated.
Push untill the desired
source is selected.
The refrigerator automatically
select the best source available
(in order: mains, battery, gas)
The refrigerator is powered from
the mains.
The refrigerator is powered from
the battery of your vehicle.
The refrigerator is powered from
the gas connection of a gas
bottle.
The performance of the refrigerator,
when operating on 12V, is dependent on the
thickness and length of the wiring and the overall
installation of the vehicle.
Sufficient power and voltage must be available
in order for 12 V units (e.g. refrigerator, ATC, etc)
to operate reliably while travelling. In rare cases,
due to the towing vehicle's battery management
system, in some car models there may not be
enough power and voltage available for external
units. If this is the case, please contact the car
manufacturer directly for further information.
To secure optimal performance, deactivate
the start/stop system on your vehicle if
present.
When selecting gas, the flame should be ignited
within 30 seconds. If the system fails, restart the
refrigerator and select the gas
source again.
For safety reasons it is not possible to ignite the
flame within 15 minutes after driving.
From about 1000 m above sea level problems of a
physical nature can occur when lighting the gas.
This does not mean that the refrigerator is not
working properly.
5 Selecting cooling level
Lowest
cooling level
Your refrigerator meets the climate class SN
requirements according to EN ISO 15502:2005 at
an ambient temperature 10°C to 32°C.
We advise to set the refrigerator on cooling
level 3, with an ambient temperature
between 15°C and 25°C. A higher temperature
needs a higher cooling level, a lower temperature a
lower level.
To improve the cooling performance of your
refrigerator in high temperatures, Thetford
advises to install the Ventilator Kit. It helps
to detract the warm air quicker to the vents.
The Ventilator Kit is suitable for all Thetford
refrigerators.
108
After switching on the
refrigerator, push the
cooling level button several
times, as illustrated. Push
untill the desired level is
selected.
Highest
cooling level