Facom FCF894 Manual Original página 27

Mode Selector (Fig. A)
Your tool is equipped with a mode selector 8 which allows you to select one of two speeds or the "Precision Control" mode. Select the speed/
mode based on the application and control the speed of the tool using the variable speed trigger switch 1
NOTE: In Speed 1, the tool will run at 900RPM in forward, and maximum speed in reverse, similar to air tools.
Worklight (Fig. A)
There is a worklight 7 located on the foot of the tool. The worklight is activated when the trigger switch is depressed, and will automatically
turn off 20 seconds after the trigger switch is released. If the trigger switch remains depressed, the worklight will remain on.
NOTE: The worklight is for lighting the immediate work surface and is not intended to be used as a flashlight.
«Precision Control» Mode
In addition to low speed impacting modes, this tool features the «Precision Control» mode which grants the user greater control in both
fastening and loosening applications. When set in forward, the tool will fasten at 2000 RPM until impact begins.
The tool will then pause for 0.5 seconds before continuing to impact at a rate of 3100 IPM, providing the user with greater control and
reducing the chance of overtightening or damaging material.
When set in reverse, the tool will impact at a normal speed and rate of 3100 IPM. Upon sensing that the fastener has broken free, the tool
will cease to impact and will reduce speed to help prevent "run-off" of loose hardware.
Anvil (Fig. E)
WARNING: Use only impact accessories. Non-impact accessories may break and cause a hazardous condition. Inspect accessories
prior to use to ensure that it con tains no cracks.
CAUTION: Inspect anvils, detent pins and hog rings prior to use. Missing or damaged items should be replaced before use.
Place the switch (2) Forward/Reverse Control Button, in the locked off (center) position or remove battery pack before changing accessories.
To install an accessory on the hog ring anvil, firmly push accessory onto the anvil 3 . The hog ring 9
compresses to allow the accessory to slide on. After accessory is installed, the hog ring applies pressure to help
provide accessory retention.
To remove an accessory, grasp the accessory and firmly pull it off.
Usage
Your impact tool can generate maximum 813Nm breakaway torque.
NOTE: Output torque is dependent on the speed selected.
NU-FCF894_0518.indd 27
F
Anvil with Hog Ring (Fig. E)
27
4
E
9
3
16/07/2018 16:12:35