Ryobi R18USB Traducción De Las Instrucciones Originales página 286

EN
RYOBI WARRANTY APPLICATION CONDITIONS
®
In addition to any statutory rights resulting from the purchase, this product is covered by a warranty
as stated below.
1. The warranty period is 24 months for consumers and commences on the date the product was
purchased. This date has to be documented by an invoice or other proof of purchase. The product
is designed and dedicated to consumer and private use only. So there is no warranty provided in
case of professional or commercial use. This warranty applies only on new products.
2. There is a possibility to extend for a part of the range of power tools (AC/DC) the warranty period
over the period described above using the registration on the www.ryobitools.eu website. The
eligibility of products for extended warranty is clearly displayed in stores and / or on packaging
and is contained within the product documentation. The end user is required to register his/her
newly-acquired products online within 30 days from the date of purchase. The end user may
register for the extended warranty in his/her country of residence if listed on the online registration
form where this option is valid. Furthermore, end users must give their consent to the storage of
their personal data that is required to be entered online. They must also accept the terms and
conditions. The registration confirmation receipt, which is sent out by e-mail, and the original
invoice showing the date of purchase will serve as proof of the extended warranty.
3. The warranty covers all defects of the product during the warranty period due to faults in
workmanship or material at the purchase date. The warranty is limited to repair and/or
replacement and does not include any other obligations including but not limited to incidental
or consequential damages. The warranty is not valid if the product has been misused, used
contrary to the instruction manual, or has been incorrectly connected to a power supply. This
warranty does not apply to:
– any damage to the product that is the result of improper or lack of maintenance
– any product that has been altered or modified
– any product where original identification (trade mark, serial number) markings have been
defaced, altered or removed
– any damage caused by non-observance of the instruction manual
– any product not displaying the CE approval mark on the rating plate
– any product that has been attempted to be repaired by a non-authorised warranty service
centre or without prior authorisation by Techtronic Industries
– any product connected to improper power supply (amps, voltage, frequency)
– any damage caused by external influences (water, chemical, physical, shocks) or foreign
substances
– normal wear and tear spare parts
– inappropriate use, overloading of the tool
– use of non-approved accessories or parts
– Power tool accessories provided with the tool or purchased separately, including but not
limited to screw driver bits, drill bits, abrasive discs, sand paper and blades, lateral guide, etc.
– Components (parts and accessories) subject to natural wear and tear, including but not limited
to service & maintenance kits, carbon brushes, bearings, chuck, SDS drill bit attachment or
reception, power cord, auxiliary handle, transport carry case, sanding plate, dust bag, dust
exhaust tube, felt washers, impact wrench pins & springs, etc.