ZAMST ZK-7 Instrucciones De Uso página 2

1.
Unfasten all the hook-and-loop fasteners of the product.
Confirm the top/bottom, inside/outside, and front/back of
the product.
Tag
<Front of the product>
Place the side with the size tag on the back of the product face
down when attaching the product to your knee.
2.
With the logo facing up, hold the product with both hands
and slide it up to your knee until the top edge of the patella
opening is approximately 2 cm (0.8 inches) above the top of
your patella.
Logo mark
Position of
patella
Align the center of the product with the center line of your patella
and adjust the product so that the patella pad encircles your patella.
When sliding the product up, hold the upper part of the active resin
stays.
3.
Straighten your knee and fasten hook-and-loop fastener A.
Hook-and-loop
fastener A
4.
Fasten hook-and-loop fastener B for appropriate compression.
Hook-and-loop
fastener B
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of
the member state in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
<Back of the product>
Patella pad
2 cm
(0.8 inches)
Center line
of patella
Fasten hook-and-loop
fastener A while pulling it
diagonally downward so
that the patella opening
fits the patella.
Refasten each hook-and-
loop fastener repeatedly
until appropriate
compression is created.
5.
Fasten the cross straps below the knee.
①
6.
Straighten your knee and pull the product to eliminate
slack.
Active resin
stays
7.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
The product correctly fastened (right leg)
<Front view>
How to remove
When taking the product off, hold the lower part of the active resin stays.
CAUTION
Do not pull the product with excessive force; otherwise, it may be
damaged.
Fasten cross straps
②
and
shown in the diagram.
* When it is used
together with tape on
the knee, a greater
Cross straps
fixing effect is created.
* Be sure to pull both
straps with equal force.
②
Pull up the slack on the
back of your knee.
<Side view>
Active resin
stays
①
below the knee as
<Back view>