DeWalt PA3500 Manual De Instrucciones página 42

English
Barrel can only be pressed against the
surface with much force:
Cause(s)
Foreign object in the
barrel or piston guide
Interior parts of the
device dirty or worn
Bent barrel
Barrel is ¿ rmly pressed against the surface,
but the shooting nails are not ¿ red when
pulling the trigger:
Cause(s)
Barrel not pressed
¿ rmly enough against
the surface
Non-approved shooting
nails
Foreign object in the
barrel or piston guide
Powder Actuated Tool
defective
Shooting nails do not penetrate deep
enough into the material to be fastened:
Cause(s)
Firing strength too low
Shooting nail too long
Target material too hard
42
Measure(s)
See chapter 5
"Inspection and
cleaning"
Have the Powder
Actuated Tool be
repaired by an
authorized specialist
workshop
Measure(s)
Press the barrel harder
against the surface
See chapter 2.3
"Shooting nails" and
chapter 6 "Technical
data"
See chapter 5
"Inspection and
cleaning"
Have the Powder
Actuated Tool be
repaired by an
authorized specialist
workshop
Measure(s)
Set the ¿ ring strength
(power regulator) to
a higher level, see
chapter 3.4 „Test
attachment".
Insert the cartridge strip
with the next higher
charge/¿ ring strength,
see chapter 2.2
„Cartridge strips"
Use a shooting nail
that matches the target
material
Cause(s)
Shooting nail strikes
hard foreign objects in
the target material, such
as nails
Powder Actuated Tool
has to be serviced
Shooting nails penetrate too deep into the
material to be fastened:
Cause(s)
Firing strength too high
Shooting nail too short
Target material too soft
Shooting nail hits
cavities or soft foreign
objects in the target
material
Measure(s)
Aim the Powder
Actuated Tool
elsewhere
Test the Powder
Actuated Tool
elsewhere on the target
material
Have the Powder
Actuated Tool be
serviced/maintained by
an authorized specialist
workshop
Measure(s)
Set the ¿ ring strength
(power regulator) to
a lower level, see
chapter 3.4 „Test
attachment".
Insert an cartridge strip
with a lower charge/
¿ ring strength, see
chapter 2.2 „Cartridge
strips"
Use a shooting nail
that matches the target
material
Test the Powder
Actuated Tool
elsewhere on the target
material
Test The Powder
Actuated Tool on
a different target
material