Publicidad
STEP 3 - Insert and tighten hook onto the end
pole at desired height/tension for your ham-
mock.
TO ADJUST THE BASE LENGTH
1 - Unscrew the 2 thumb screws and remove.
2 - Slide hammock stand outwards from center
poles to expose the (D) inner support pole.
3 - Once the desired length is adjusted, line up
the holes in the (C) center base poles with the
(D) inner support pole (silver) and secure with
the 2 thumb screws.
A
STEP 5 - This is how your stand should look completely closed.
MAINTENANCE
1. For best results and longer life, store your stand out of the weather to reduce possible rust problems.
2. BEFORE EACH USE, INSPECT ALL MOUNTING HARDWARE, STAND PARTS, POINTS OF CONNEC-
TION AND YOUR HAMMOCK FOR INDICATIONS OF TEAR OR DEFECTS, REPLACE ALL WORN PARTS
PRIOR TO USE OF YOUR STAND OR HAMMOCK.
3. Should the painted surface become scratched or chipped, obtain a matching paint and touch up spots
where the underlying metal is exposed to inhibit rust.
CAUTIONS AND WARNINGS
DO NOT allow the connections (where one part inserts into another part) to become loose or less than totally
inserted. Inspect prior to every use, to make certain that one part is fully inserted into the other part.
DO NOT EXCEED THE SUGGESTED WEIGHT LIMIT FOR YOUR HAMMOCK STAND
QUESTIONS:
If you should have any questions, problems or comments, please call our Customer Service Department at
1-800-231-1402 or e-mail info@texsport.com. This Department is open M–F from 8 a.m.–5 p.m. CST.
C
B
C
D
(inside)
A
B
Publicidad
