Sears Kenmore 116.32920 Manual Del Propietário página 8

HANDLE MOUNTED
To start the vacuum cleaner, slide the
ON/OFF switch from the OFF position to the
FLOOR or CARPET position. To stop the
vacuum cleaner, slide the ONIOFF switch to
the OFF position.
CAUTION
Refer to your carpet manufacturers
cleaning recommendations. Some
more delicate carpets may require that
they be vacuumed with the agitator
turned off, to prevent carpet damage,
OFF - turns both suction and brush motors off,
FLOOR - turns on the suction motor only, In
this position the brush assembly does not
revolve. Use this setting for cleaning hard-
wood and tile floors and when any attach-
ments (tools) are used,
CARPET - turns on both the suction and
Note: Agitator will not turn until the handle
is activated in either FORWARD or
REVERSE. Agitator will only turn when
switch is in CARPET mode only,
V. cAuT:,o j .........................
Do not allow vacuum cleaner to
remain in one spot for any length of
time when the agitator is turning,
Damage to carpet may occur,
,, , ,, , , , , , ,,
CARPEl
the brush motors.
---Selector
Window
This vacuum cleaner is equipped with a
variable power control which will allow you
to select any cleaning power from low to
high.
Set to LOW suction power for delicate
fabrics such as draperies. Set to MAX or
full power for more conventional carpet or
bare floor cleaning,
To set to MAX suction power, move the
control knob fully to the right,
Low Suction
Power
_ Full Suction
Variable
PoweJ ii\ 1
Control
Note: When the varible power control is
set to LOW the stronger the pull forces
wil! be at the agitator,,
Release the handle by pressing down on
the handle release pedal with your foot and
pulling back and down on the handle with
your hand,
Note: The agitator wilt not rotate if the vacu-
um cleaner is in the upright position.