Barrette EPN-51293 Manual De Instrucciones página 4

4.
The collet is reversible and has a text molded into the
part to identify the direction. If using a 0.06 or 1/16"
wall post the collet should be oriented so the 1/16"
marking is facing up. Flip it over to use on a 0.125 or
1/8" thick post (Fig. 6).
5.
Re-orient the cap nut and collet according to the
wall thickness of post and thread the hex bolt thru
the bottom of the base into the cap nut. Do not over
tighten the hex bolt, nger tighten only at this point
(Figs. 7&8).
6.
Measure down from the routed hole to mark your cut.
Your measurement should be your desired bottom
space minus 3/8" (Fig. 9).
Example:
For a 2" bottom space, measure down
2" – 3/8" = 1 5/8"
After marking, cut your posts.
7.
Insert cut post into surface mount assembly
completely until the post bottoms out in the base
(Fig 10).
4
Top View Bottom View
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10