Resetting To The Factory Default Settings - Axis Communications AXIS 207 Manual Del Usuario

Page 10
Accessing the AXIS 207 from the Internet
Once installed, a camera is accessible on your local network (LAN). To access the camera from
the Internet you must configure your broadband router to allow incoming data traffic to the
camera. One method for this is NAT traversal via port mapping.
For more information, please refer to the AXIS 207 User's Manual which is available on the CD
included in this package and from the Axis Web site at http://www.axis.com.
See also the AXIS Internet Dynamic DNS Service at www.axiscam.net

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the AXIS 207.
2. Press and hold the Control button and reconnect power.
3. Keep the button pressed until the Status Indicator displays yellow (this may take up to 15
seconds), then release the button.
4. When the Status indicator displays green (which can take up to 1 minute) the AXIS 207 is
reset to the factory default settings.
5. Re-install the AXIS 207 using one of the methods described in this document.
More information
For more information, please see the AXIS 207 User's Manual, which is available on the CD
included in this package. Updated versions can be obtained from www.axis.com
AXIS 207 Installation Guide