Connecting The Drive Via Esata - Toshiba PH3064U-1EXB Manual Del Usuario

After you activate or install a feature, the (
the feature.
NOTE
NOTE

Connecting the drive via eSATA

If your computer has an eSATA connector, you can connect the
external hard drive to the computer with an eSATA cable (sold
separately) instead of a USB cable, if you wish.
Please note, for initial drive setup and software installation, the
drive must be connected via USB. Once you have installed the
software via USB, you can use the software via an eSATA
connection.
If you decide to install one or more of the software applications at a
later date, please note the drive must be connected to the computer
via USB to access the Setup window. The Setup window is not
accessible when the drive is connected via an eSATA cable. After
software installation, you can use the software in eSATA mode.
The Setup window displays each time you connect the drive to your
computer with a USB cable, until you have activated all of the
applications or until you select the "Do not show the Setup window
next time" checkbox.
To access the Setup window again after disabling it:
1. Make sure the drive is connected to the computer with a USB
cable (not an eSATA cable).
2. In My Computer or Computer, right-click the Virtual CD ( ) icon,
and select Open from the shortcut menu.
3. Double-click the Launch Setup (
about the Virtual CD, see
Never connect the drive to a computer with both a USB cable and an
eSATA cable at the same time. Doing so could damage the drive
and/or the computer and may cause data loss.
Connecting the drive via eSATA
) icon. For more information
"Drive partitions" on page
) icon displays next to
14.
13