Respecting And Conserving The Environment; Troubleshooting - Hotpoint 4D TVZ Serie Manual De Instrucciones

The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the
appliance it must be separately collected. Consumers should
contact their local authority or retailer for information
concerning the correct disposal of their old appliance.

Respecting and conserving the environment

• Install the appliance in a fresh and well-ventilated room.
Ensure that it is protected from direct sunlight and do not
place it near heat sources.
• Try to avoid keeping the door open for long periods or
opening the door too frequently in order to conserve energy.
• Do not fill the appliance with too much food: cold air must
circulate freely for food to be preserved properly. If circulation
is impeded, the compressor will work continuously.
• Do not place hot food directly into the refrigerator. The internal
temperature will increase and force the compressor to work
harder and will consume more energy.
• Defrost the appliance if ice forms ( see Maintenance ). A thick
layer of ice makes cold transference to food products more
difficult and results in increased energy consumption.
• Regularly check the door seals and wipe clean to ensure they
are free of debris and to prevent cold air from escaping ( see
Maintenance ).
• Thanks to its independent freezer door and drawer opening
system, this product offers a 50% energy saving in comparison
with a normal 2-door combined refrigerator/freezer unit.

Troubleshooting

If the appliance does not work, before calling for Assistance (see
Assistance), check for a solution from the following list.
The green POWER indicator light does not illuminate.
• The plug has not been inserted into the electrical socket, or not
far enough to make contact, or there is no power in the house.
The motor does not start.
• The appliance comes with a motor protection control ( see
Start-up and use ).
The indicator lights are on but the light is dim.
• Pull out and reverse the plug before putting it back in the socket.
a) The alarm sounds.
a) The refrigerator door has remained open for more than two
minutes (the buzzer will stop sounding when you shut the door)
or the correct switching-off procedure was not followed ( see
Maintenance ).
b) The alarm sounds and the two yellow indicator lights
flash.
b) The temperature in the freezer is too high. Check the quality of
the food products and dispose if necessary.
+ buzzer =
Heating is excessive
c) The alarm sounds and the two yellow indicator lights as
well as the green one flash.
c) The temperature in the freezer has reached a dangerous
level. The food must be disposed immediately.
+ buzzer =
Heating danger
All manuals and user guides at all-guides.com
b/c) In both these cases the freezer will maintain a temperature
of about 0°C so that the food does not re-freeze.
To turn off the acoustic signal open and close the refrigerator
door. To restore normal operation bring the FREEZER
OPERATION knob setting to
on again.
d) The yellow SUPERFREEZE indicator light flashes
d) The Optimization Energy Saving function is activated.
The green POWER indicator light flashes.
• The appliance is not operating correctly. Contact the Technical
Assistance Centre.
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The OPERATION knobs are not on the correct setting ( see
Description ).
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The REFRIGERATOR OPERATION knob is not on the correct
setting ( see Description ).
• The food is in contact with the back inside wall of the
refrigerator.
The motor runs continuously.
• The SUPER FREEZE button has been pressed (rapid
freezing): the yellow SUPER FREEZE light is on or flashing
( see Description ).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface ( see
Installation ) .
• The appliance has been installed between cabinets that
vibrate and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
The back wall of the refrigerator unit is covered in frost or
droplets of water
• This shows the appliance is operating normally.
(off) and turn the appliance
27
GB