Publicidad
The EAntenna EA270J assembly is very simple, you just need to follow these brief instructions to set correctly each piece.
The plate (EA270J_4) contains 5 holes; 3 on top and 2 on bottom. The top 3 holes is where staying three antenna elements.
EA270J_1
If we take the plate and put it in the same orientation drawing below (STEP 1), from left to right, they are positioned elements (EA270J_1), the
longest of 144.8 cm, then the shortest (EA270J_2) 15.88 cm, and finally, the item to be fed to the connector, (EA270J_3) of 48.89 cm length.
The 2 elements or rods that go to the connector, how to fix it is simple.
Must first take an item and enter the nut (S439-910) to the top of the thread, and once done, enter the item by corresponding hole in the plate
(EA270_4) and put the other nut (S439-910) to leave the rod firmly attached to the plate (EA270J_4).
Well applicable to the other member in the same way. In (STEP 2) you can see these steps
(S439-910)
STEP 1
EA270J_2
(EA270J_4)
STEP 2
ENGLISH
EA270J_3
(S439-910)
(S439-910)
Publicidad
