Publicidad
7 7
Locate the enclosed washers and the 4 bolts you removed in
Step 3. Remove the white washers from the bolts and replace
them with the black washers provided in the parts kit so the
large diameter of the washer is under the bolt head as-shown.
9a
9a
Bend the Tailgate TechLiner backward to locate the first hook
and loop pad without shifting the position of the TechLiner. For
painted surfaces, clean the hook and loop attachment point
locations with provided alcohol wipes and let dry.
10
10
Remove the plastic backing from the first hook and loop and
fold the Tailgate TechLiner back into place, pressing down
firmly. Continue the process for each hook and loop, working
your way to the other end, taking care not to remove the
plastic backing until you affix them to the tailgate.
WARNING:
It is imperative to adhere the Tailgate TechLiner to the tailgate of the truck, as described above. Failure to do so may allow the Tailgate TechLiner
to lift during travel as a result of turbulent airflow. This could cause unsafe conditions for the operator of the vehicle or other vehicles nearby.
NOTE:
Clean your Tailgate TechLiner using mild soap and water, or use our TechCare FloorLiner
(630) 769-1500
weathertech.com/warranty
© 2020 MacNeil IP LLC
8
8
Hand tighten all bolts in their original holes first, then tighten
using the supplied Torx Bit. Do not over tighten.
9b
9b
For spray-in bed liners, prep the surface with the provided
Primer 94 Ampule.* Shake the Primer 94 and push the center
to crack open. Apply to the areas the hook and loop will
occupy and let stand for 5 minutes or until dry. This step can
be skipped with standard painted surfaces.
*One ampule covers about 3 hook and loop locations and dabbing works best.
11
11
Starting at one end, begin tucking the edge of the Tailgate
TechLiner
into the plastic extrusion that you previously
®
installed. Work your way down the entire length of the tailgate.
& FloorMat Cleaner and Protector for best results.
™
Publicidad
