Pairing Our Transmitters - Siemens easyTek Manual Del Usuario

Pairing our transmitters

Each transmitter has to be paired once with easyTek.
You can use up to two of our transmitters.
Preconditions:
easyTek is turned on.
■
Neckloop is plugged into both sides, and easyTek is
■
worn around the neck.
Transmitter is within operating distance.
■
Pairing our transmitters:
Turn on the transmitter.
X
Press , and simultaneously until the blue
X
and green LEDs flash
5 seconds.
easyTek searches for transmitters nearby.
22
All manuals and user guides at all-guides.com
. This takes approximately
Pairing may take several seconds.
The blue LED indicates the pairing status:
Pairing status for our transmitters
flashing, then on
➧
Pairing has been completed successfully. Streaming
starts automatically. You can now use the transmitter.
flashing, then off
➧
Pairing was not successful. In this case, ensure that the
transmitter is within operating distance and try again.
You can also use the easyTek App for pairing.
Further information:
If the transmitter is only temporarily (< 5 min) out
■
of operating distance, the transmission of the audio
signal is interrupted but automatically picked up again
when the transmitter is back within operating distance.
If a transmitter is already paired, you cannot pair it
■
again.
If you pair a third transmitter, the first paired
■
transmitter is automatically unpaired.
23