SATA 95121 Manual De Instrucciones página 2

Tool Trolley:
SATA Tool Trolley uses the lock sheet on the top drawer to control the rear locking device to switch all drawers.
Attention:
Before Iocking the box, please make sure the drawer is completely closed. Do not hit the unlocked drawer so as
not to damage the locking device. If this happens, please try to repairthe lock with pliers
Casters:
All SATA Tool Trolley are equipped with load-bearing wheels. Each vehicle has two fixed casters and two directional wheels
with brakes.
Lubrication:
In order to improve the use efficiency, please pay attention to the regular use of light grease lubrication tool car slides, it
is recommended that at least twice a year, or increase the number of times according to the use.
Warranty clause:
SATA products promise free replacement of materials, defective products in process. Product damage caused by misuse or
abuse is not covered by warranty. Tool cars should be used in relatively static locations, but not in dynamic environments,
such as mobile vehicles.
How to disassemble drawers with ball bearing slides:
Note that there is a black clip spring on the slide rail of the drawer. To remove the drawer, press down the spring on the
left slide rail at the same time, press up the spring on the right slide rail, and then pull out the drawer by force.
How to Reload Drawers:
Just insert the drawer into the slideway slot and push it hard to the bottom.
95121/95123
中文
EN DE RU KO PT JA ES