6"
Set
Screw
Set Screw
Cover
PAGE 2 OF 15
Leg
Undershelf
6"
Side
Panel
ASSEMBLY
1.
With the undershelf on its side, push the legs through
the collars. (See Figure 1)
NOTE: In order for the tabletop to sit flush, the
distance from the bottom of the leg tube to the
6"
bottom of the shelf leg collar, must be 6". To
ensure exact height, mark desired height on
each leg with magic marker or grease pencil.
6"
Figure 1
2. Secure legs to undershelf with set screws using 5/32"
Figure 2
Allen wrench. Place set screw covers over screw
opening. (See Figure 2)
NOTE: Bottom shelf set screws located on
corner legs must be covered in order to meet
Set
NSF standards.
Screw
NOTE: Undershelf must be level. Use care not to
overtighten screws or failure will occur.
3. Insert short legs into center collars. Secure legs to
A
undershelf with set screws using 5/32" Allen wrench.
(See Figure 2A)
4. Stand table upright and place side panels over legs
with long lip facing down. Secure to bottom shelf
with two large Phillips head bolts per side panel.
(See Figure 3)
Figure 3
0220 IH-8182