Tabla de contenido
Publicidad
English
Installation
---------------------------------------------------
In order to fix the cooker hood to the kitchen
unit you can choose one of these three
possibilities:
a) To the upper part of the furniture, using
figure 4 where the position of the holes
denominated "A" is indicated. This fixation
will be made from the inside part of the
cooker hood, after disassembling the
filters.
b) To the lower part of the furniture, using
figure 4 where the position of the holes
"B"
denominated
is
indicated.
It
necessary to dismantle previously the
frame, taking out the 4 screws that are
fixed to the lateral sides of the body hood.
This fixation will be made from the inside
part
of
the
cooker
hood,
disassembling the filters. In order to
assemble the frame again once the hood
is installed, you will proceed in the inverse
way.
TEKA INDUSTRIAL, S.A. reserves the right to make corrections in its appliances wherever it
considers these necessary or useful, without harming their essential features.
All manuals and user guides at all-guides.com
c) To the internal laterals of the furniture
through floating holes denominated "C", wich
exist in each side of the body hood. This
fixation will be made from the inside part of
the cooker hood, after disassembling the
filters.
The lower part of the extractor must be
installed a minimum height of 60 cm
above the hob for electric cookers and 65
cm for gas cookers. (If the installation
instructions of a gas cooker indicate a
greater distance this must be observed.
When the extractor is working at the same
time
as
other
non-electrical
equipment, the outlet air pressure must not
-5
exceed 4 Pa (4 x 10
bar).
To achieve optimum performance the length
is
of the outlet hose should not exceed 4
meters, or include more than two 90º angles
(elbows)
Although
venting
to
the
recommended, activated carbon filters may
after
be used, which allow the gas to be returned
to the kitchen through the outlet pipe.
If something does not work
---------------------------------------------------
Before seeking technical assistance carry
out the following checks first:
Special U.K. Requirements
---------------------------------------------------
Height above gas hob: 75 mm minimum.
NEVER PLACE THE COOKER HOOD OVER
AN EYE-LEVEL GRILL.
This appliance must be connectec by a
competent person, using fixed wiring via a
DOUBLE POLE SWITCHED FUSED SPUR
OUTLET.
Electrical connection
---------------------------------------------------
We recommend that the appliance is connected
by a qualified electrician, who is a member of
the N.I.C.E.I.C. and who will comply with the
cooking
I.E.E. and local regulations.
Should the colour of the wires in the mains lead
for the appliance not correspond with the
coloured markings identifying the terminal in
your spur box proced as follow:
* The wire which is coloured blur must be
connected to the marked N (Neutral) or
coloured Black.
* The wire which is coloured brown must be
connected to the marked L (Live) or couloured
outside
is
Red
* Where avialable (see installation), the wire
which is coloured yellow/green must be
connected to the market or coloured
Yellow/Green.
If the cooker hood is installed for use above a
gas appliance then the provision vor ventilation
must be in accordance with the Gas Safety
(Installation & Use) Regulations 1984 and the
relevant
Building
recommendations are contained in the following
British Standard Codes of Practice BS6172,
BS5440 and BS6891 Current Edition.
This apparatus has the marked CEE in conformity with Standard 2002/92/EC of the European
Parliament and the Council about remainers of electrical en electronic apparatuses. The correct
elimination of this product avoids negative consequences for the market and the health.
Symbol
(In the product or in the documents that are included with it), indicates that it's not
possible to be treated like domestic remainder. It's necessary to give it in a collection point to
recycle electrical and electronic apparatuses. Get rid of it in accordance with the environmental
norms for remainders elimination.
In order to obtain detailed information about the treatment, recovery or recycling of this product,
put yourself in contact with the city council, with the elimination service of urban remainder or
with the store where you acquired the product.
Special Australia Requirements
---------------------------------------------------
* This appliance is not intended for use by
young children or infirm persons without
supervision.
* Young children should be supervised to
ensure that they do not play with the
appliance.
Regulations.
Detailed
Publicidad
Tabla de contenido
