Oil Pump; Use Instructions; Product Description; Safety Warnings - HP Autozubehor 20.260 Modo De Empleo

GB
Art. No.
20.260

Oil pump

Dear customers!
Before using this product, please read the Use Instructions and follow them carefully. Keep the Use
Instructions for further reference.

Product description:

This oil pump is designed for clean replacing of oil and/or draining engine oil, diesel or fuel oil.
1. Pumping well ø 6 mm
2. Pumping hose ø 10 mm
3. Oil pump
4. Outlet hose ø 10 mm
5. ON/OFF switch
6. Power cord with battery clips 12

Safety warnings:

- Do not pump gasoline, kerosene or other highly flammable liquids! EXPLOSION HAZARD!
- Do not pump water or gear oil: this may cause damage to the pump.
- When connecting the battery clips, keep correct polarity!
- Always switch the engine off when pumping.
- Always heat engine oil up before pumping!
- Never let the pump "running idle" When oil pumping is interrupted, switch the pump off immediately.
- Collect the used oil in a container of sufficient capacity. Make sure that oil does not leak into earth or
sewerage! Dispose of in a used oil disposal facility!!!
Caution:
The oil pump is designed to run for approx. 15 minutes. After that, let the pump cool down.
Oil pump Use Instructions:
1. Before replacing oil, heat the engine up until the temperature reaches approx. 40 - 60°C.
2. Switch off the engine!!
3. Insert the pumping well (1) and the pumping hose (2) in the suction neck and insert the outlet hose in
the outlet neck of the pump. To make sure that the hoses do not let loose, fasten them using the clips
supplied.
4. Insert the pumping well (1) into the oil-gauge hole down to the deepest point of the engine sump.
5. Put the outlet hose (4) into a suitable container.
6. Now, connect the oil pump to the battery. KEEP CORRECT POLARITY!!!
(black clip to the negative pole, red clip to the positive pole)
7. Switch the oil pump on (5) and start pumping.
8. When pumpin g is finished, switch the pump off. Never let the pump "running idle"
9. Refill the engine with new oil according to the car manufacturer's instructions. Next, check the oil level
using the oil gauge.
Caution: After finishing the job, clean the pump and its accessories properly; keep it in a dustproof place.
Technical data:
Operating voltage:
Current consumption:
Engine power:
Max. pumping power:
Pumping system:
➞ ➞ ➞ ➞ ➞
:

Use Instructions

DC 12 V
approx. 5 A
approx. 60 W
approx. 3l / min (at oil temperature of 40 - 60°C)
vane pump
suction direction (see the sticker on the pump)
4