Publicidad
Idiomas disponibles
Idiomas disponibles
Park Tool Co.
5115 Hadley Ave. N., St. Paul, MN 55128 (USA) www.parktool.com
Assembly
A. Secure bench support weldment (#14) to bench using ap-
propriate through bolts or lag bolts (not included).
B. Select desired mounting hole on bench support weldment
and attach horizontal tube (#3) using hex head bolt (#12)
and washer (#13).
C. Place lock block assembly (#4-10) into square tube on hori-
zontal tube. Press end cap (#11) into top of bench support
weldment.
D. Place clamp (#1 or #2) into horizontal tube and tighten
handle of lock block assembly to secure.
Clamp Rotational Adjustment
The clamp on the PRS-4.2-1 and PRS-4.2-2 can be rotated 360
degrees, allowing easy access to any component of the bike. To
adjust the angle of the clamp:
A. Loosen handle on lock block assembly (#9).
B. Rotate clamp (#1 or #2) to desired position.
C. Retighten handle of lock block assembly to secure clamp.
PRS-4.2-1 (with 100-3C Adjustable Linkage Clamp)
PRS-4.2-2 (with 100-3D Micro Adjust Clamp)
4
1 0
Deluxe Bench Mount Repair Stand
3
1 1
PRS-4.2-1 / PRS-4.2-2
Notes
Some bike manufacturers recommend not clamping thin-walled
or carbon fiber frames. Consult the manufacturer for suggested
clamping locations.
To avoid damage to the finish, clean the bike tube and jaw covers
before clamping.
The two clamping jaws each have a recess to provide clearance
for cables. Make sure any brake or shift cables are in one of the
recesses before clamping.
Keeping the front of the bike slightly lower than the back will help
prevent the front wheel and handlebars from flopping and hitting
the frame's top tube. A Park Tool HBH-2 Handlebar Holder can be
used to prevent handlebar flopping if the bike is being rotated in
the repair stand.
12
13
14
1
OR
2
Publicidad
