BTC 9001URF Guia De Inicio Rapido página 2

All manuals and user guides at all-guides.com
USB Wireless Keyboard & Mouse Kit Quick Installation Guide
Hardware Installation
Slide Switch Setting
1. Connect the receiver to your PC by plugging in
the receiver connector into your PC.
2. Take the receiver and select channel CH1 or
CH2 by using the slide switch on the back of the
receiver. (Remember your selection.)
3. Take the keyboard and make sure the batteries
on the back are installed correctly. (Follow the
polarity signs in the battery compartment.)
4. Use the slide switch on the back of the keyboard
to select the same channel as the one selected
in step 3 on the receiver.
5. Take the mouse and make sure the batteries on
the back are installed correctly. (Follow the
polarity signs in the battery compartment.)
6. Use the slide switch on the back of the mouse to
select the same channel as the one selected in
step 3 and 5.
ID Button Setting
This ID-recognition function helps to protect against
interference from other RF keyboards in the same
environment. Remember to set the ID when you
replace the batteries or your keyboard kits do not
work properly.
The word CONNECT labels the ID button on each
unit.
The LED under ID button of receiver shows
connecting condition.
1. Your PC must be on to change the ID setting.
2. Press ID button on the top of the receiver once.
3. Press ID button on the bottom of the mouse
once.
4. Press ID button on the bottom of the keyboard
battery compartment once.
Important:
1. Use the mouse only on a clean, flat, non-slippery surface in order to ensure smooth and
accurate cursor action.
2. You can adjust the double-click speed of mouse by opening up the Mouse Properties in the
Windows Control Panel and changing the speed.
Software Installation
Keyboard Driver Installation
In order to take advantage of the special button functionality of the keyboard you will have to
install the keyboard driver which is located on the driver disk included in the box.
1. Remove any existing keyboard software from the computer.
2. Insert the driver disk in your computers, and run "SetupKey.exe".
3. Follow the on screen instructions to finish the installation procedure. The driver default will be
installed at C:\Program Files\KMaestro.
Back View of Receiver Plug
Front View of Receiver Plug
(-)
utton
Bottom View of Mouse
ID Button
ID Button of Receiver
utton
ID Button of Mouse
ID Button of Keyboard
CH2 CH1
ID Button
9001URF QG 英
3100505110 v1.3
CH2
CH1
Battery 1.5V 2pcs
ID Button
(+)
Slide Switch
Slide Switch Setting
of Mouse