Fcc Statement - Spector&Co T1033 Guia De Inicio Rapido

All manuals and user guides at all-guides.com
T1033 Product Map
Switch button
LED light
Integrated dual
micro-USB/8-pin adapter
To Charge T1033
1. Insert the micro USB output of the charging cable into the T1033 & connect USB output to a wall
adapter (not included).
2. LED will light RED while charging & will turn off once the T1033 is fully charged (charging will stop
automatically once the T1033 is fully charged).
To charge electronic devices using the T1033
1. Swipe the switch button to gain access to the integrated dual micro-USB/8-pin adapter.
2. Insert the USB output into T1033 & connect the micro USB output into your electronic device.
3. Charging will stop automatically once the device is fully charged.
CAUTION:
Risk of Fire and Burns, don't open, crush, disassemble and dispose of in fire. Accessible surfaces held or
touched for short periods only. Don't heat above 50 °C or Incinerate. Follow Manufacturer's Instructions

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Micro-USB input port
Silicone strap