Descargar Imprimir esta página

mothercare Convertible Guia Del Usuario página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

fig 3
Harness
Ring
I
J
K
H
fitting the tray
fig 4
fig 5
3
When fitting the chair to the
table for use as a highchair,
ensure that the table surface
"H" is at the rear.
The lower rail of the chair
frame must sit squarely
on the cross rails "I"
and "J" and the front legs sit
squarely in the rear notches of
the footrest "K"
Refer to the diagram for
guidance.
Attach a safety harness to the
metal rings at the rear of the
right and the left chair frames
"A" and "B".
WARNING: FAILURE TO ATTACH THE
TRAY IN ACCORDANCE WITH THE
INSTRUCTIONS COULD RESULT IN
THE CATCHES BREAKING.
On the underside of the tray "L"
attach the two Tray Brackets "O"
using the four Screws "P"
Ensure the spring loaded pins are
facing outwards.
(as shown in fig 4)
Once the Tray Brackets have been
secured to the underside of the Tray,
slide the locating ribs on the inside
faces of the Brackets onto the
corresponding grooves on the
outside of each chair frame. Pull
both spring loaded pins outwards
until they click into one of the two
locating holes in each groove.
(shown in fig 5)
care of your product
Periodically check all fittings to ensure that none have come loose.
The highchair can be cleaned by wiping with a damp cloth and drying with a soft
dry cloth.
Never clean with abrasive, ammonia based, bleach based, or spirit type cleaners.
Take care when handling or moving the highchair. Careless handling can damage
safety notes
WARNING: Do not leave the child unattended. A safety harness does not replace
adult supervision.
WARNING: do not use the highchair unless all components are correctly fitted and
adjusted.
WARNING: Ensure harness is correctly fitted.
WARNING: Be aware of the risk of open fires and other sources of strong heat, such
as electric bar fires, gas fires etc, in the vicinity of the highchair.
The chair must be used with a safety harness approved to BS6684:1989, correctly
fitted and adjusted.
The Highchair must be used on a level and stable surface.
Once assembled, do not disassemble the highchair.
Strong heat sources, e.g. open, electric or gas fires in the vicinity of the highchair
may be dangerous if placed near the highchair.
Keep away from trailing cords, drapes or flexes, and away from electric sockets.
Never move (including rocking) the highchair with the child in it.
Never allow older children to climb on the highchair, especially while there is a child
in it.
4

Publicidad

loading