Mark BEAM 201 Instrucciones De Usuario página 7

All manuals and user guides at all-guides.com
5.2 POWER PROTECT
The equipment must be operated by professionals; Make sure that the voltage of
power supply must be comply with the voltage identified on the lamp, and must have
an overload or leakage electrical protection.
ATTENTION!
Factory has equipped the standard 3 pin plug socket. Connect the power supply as
below table.
If lamp cable is damaged, replacement should be operate by factory or qualified
staff. Any question, please contact professionals or talk to a qualified electrician.
Live wire(L)
RED
6. LAMP
6.1 LAMP DESCRIPTION
LAMP MODEL
Philips UHP
YODN 5R
YODN 7R
WARNING! There is a safety hazard or damage if install similar bulb
To reduce the risk of damage to light ,do change the lamp before using
time over 125% of lamp life .
6.2 LAMP REPLACE
Attention! When replace the lamp is forbidden to touch lamp with bare hand, to
avoid the greasy dirt stains filament. filament must be kept clean
1. Disconnect the power. Before replace lamp, fixture need 20 minutes for lamp
cooling. Fasten the head with Y axis protect lock in 60 ° position.
2. Use cross screwdriver to open the light body cover, remove the fan bracket,
pull out the bulb cable
3. Open stainless steel tablet holder with one hand and the use other hand to
pull out the bulb at oblique 15 °
4. Install the lamp
BEAM 201 User Manual/Manual de uso
Null(N) Ground wire
BLUE Yellow +Green
POWER OF LAMP LIFE/HOUR
189 W 2200 HOURS
200 W 2200 HOURS
230W 2200 HOURS
COLOR TEMPERATURE
8000K
8000K
8000K
Page 6
EN