Charging The Battery - Unitech PA600 II Manual Del Usuario

Charging the Battery

Turn the backup battery switch on before charging the battery. Data you
entered may not be properly stored until the built-in backup battery has been
adequately charged.
1
Press and hold the connector button on the USB charging cable and connect it
to the PA600 II (1).
2
Plug the AC adapter cable into the power jack on the USB charging cable (2).
3
Connect the AC adapter into an electrical outlet (3).
1
Using the SD/MMC memory card
1
Remove the four screws from SD compartment cover and remove the cover.
Copyright 2008 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
3
2
2
Insert the SD card with the notched
corner as shown by the icon on the case.