ION KEYSTONE Guia De Inicio Rapido página 5

Features
Speaker (Side View)
1. Charging Adapter Input: Insert the included
charging adapter here to charge the Keystone
battery.
Important: Keystone should be fully charged prior
to first use for maximum battery life.
2. Power: Press this button to turn on the Keystone.
Press and hold this button to power the unit off.
3. Bluetooth: Press this button to enter Bluetooth
Pairing mode. Press and hold to disconnect a
connected Bluetooth device.
Note: When Bluetooth is connected, Keystone will
automatically power off after 30 minutes if no audio
is playing.
4. Reset: If Keystone is working abnormally, shut
down the unit by placing a paper clip into the Reset
hole located on the Keystone control panel and
gently push until the unit turns off. Try this only after you have first attempted to reboot Keystone
using the Power button.
5. IR Receiver (Front): When using the remote, point it toward the IR Receiver located on the front
face of the speaker.
Note: If Keystone has not been used in a week, the IR Receiver will power down to conserve
battery. At this point, the remote will no longer communicate with the speaker. When this
happens, use the speaker's Power button to turn on the unit and re-enable the IR Receiver.
6. Solar Panel (Top): Once fully charged, Keystone's solar panel can provide suitable power for
typical daily use without the need to connect the charging adapter. Results will vary depending
on daily number of hours Keystone is exposed to direct sunlight.
7. Mount (Bottom): Insert the wall mount post here, and then tighten the Set Screw to secure the
speaker to it.
8. Attachment Knob (Back): This knob is used to secure Keystone to the wall mount post. Make
sure it is properly tightened.
Remote
Important: Before using the remote for the first time, remove the plastic pull tab from the battery
compartment to engage the battery.
When using the remote, point it toward the IR Receiver located on the front face of the speaker.
1. Power Button: Press this button to power the unit on and off.
2. Bluetooth Button: Press this button to enter Bluetooth Pairing mode.
3. Volume -/+: Press these buttons to decrease (-) or increase (+) the volume.
4. Play/Pause: Press this button to play or pause the streaming audio.
Tip: Press and hold this button for 3 seconds to disable (or enable) the
voice prompts.
5. Prev: Press this button to go to the previous track on your device.
Note: In some apps, pressing Prev may go to another playlist or music
genre.
6. Next: Press this button to advance to the next track on your device.
Note: In some apps, pressing Next may go to another playlist or music
genre.
6
6
2
3
1
4
5
8
7
2
1
3
VOL.
5 4 6