Silver Eagle SE1200 Guia De Inicio Rapido página 3

TOOL USE AND CARE
• Use clamps or other practical way to secure and
support the workpiece to a stable platform. Holding
the work by hand or against your body is unstable
and may lead to loss of control.
• Do not force tool. Use the correct tool for your
applications. The correct tools will do the job better
and safer at the rate for which it is designed.
• Do not use tool if switch does not turn it on or off.
Any tool that cannot be controlled with the switch is
dangerous and must be repaired.
• Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
• Store idle tools out of reach of children and other
untrained persons. Tools are dangerous in the hands
of untrained users.
Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools, with sharp cutting edges are less likely to bind and are
easier to control.
Check for misalignment of binding or binding or moving parts, breakage
of parts, and any other condition that may effect the tool's operation. If
damaged, have the tool serviced before using. Many accidents are
caused by poorly maintained tools.
Use only accessories that are recommended by the manufacturer for
your model. Accessories that may be suitable for one tool, may become
hazardous when used on another tool.
SERVICE
Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result
in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow
instruction in the Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance instructions may
create a risk of electric shock or injury.
SPECIFIC SAFETY RULE
Hold tool by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring or its own
cord. Contact with a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
SE1200
All manuals and user guides at all-guides.com
SE1200 1/2" Electric Impact Wrench
APPLICATION
Tool can be used for tire changing, shock absorber replacement,
exhaust system work, lawn mower repair, appliance repair and small
engine work.
• Switch
Your tool starts or stops by depressing and releasing the rocker switch.
Pressing the bottom of the switch runs in forward direction. Pressing
the top of the switch runs the reverse.
• Install/remove sockets or accessories
To install a socket on the anvil, align the hole of the socket with the
anvil, push firmly.
To remove a socket from the anvil, pull the socket out firmly.
• Accessories
Proper use the standard bolt cap. (in./mm) 1-1/4" (32mm).
MAINTENANCE
WARNING: When servicing use only
identical replacement parts. Use of any other parts
may create a hazard or cause product damage.
• Do not attempt to make any adjustment while
the tool is in operation.
• Clean out any accumulated dust.
• Do not allow petroleum base on products to
come into contact with plastic parts as they
contain chemicals that can damage, weaken
or destroy plastic.
WARNING: Check extension cords before each
use. If damaged, replace immediately. Never use tool
with a damaged cord since touching the damaged
area could cause electrical shock resulting in serious
injury.
WARNING: Always remove the electric power
cord from the power supply before changing brushes,
drill bits, lubricating or when working on the unit to
avoid possible serious injury.
WARNING: This electric tool is in accordance with
the relevant safety requirements. To assure safety and
reliability, all repairs, with the exception of exter-
nal accessible brushes should be performed by an
Authorized Service Center or other Qualified Service
Organization.
3 08/03/06